Recent content by Cali HP Addict

  1. Cali HP Addict

    Camber & Stock Strut Mounts

    This isn't where I got the info but I just found it.
  2. Cali HP Addict

    Camber & Stock Strut Mounts

    Hey, I just installed a set of tires and realized that my old tires have significant wear on the very inside. Car is lowered with no camber adjusting mods currently. Thanks to this community I see that I can rotate my stock upper strut mounts 180 deg to help mediate this issue. I do have a...
  3. Cali HP Addict

    tire review help

    I just purchased a staggered set of Michelin PS4S in 265 40 r18 front & 285 40 r18 rears. I am replacing Toyo Proxes T1s and I mainly compared the 555g2 vs the PS4S in my decision. No one has mentioned that, in the case of apples-2-apples comparison, the 555g2 in 285 width is a full 5# heavier...
  4. Cali HP Addict

    Anyone tried a stock tune on a big motor?

    Honestly brother, this NA car is a blast to drive! I enjoy it more than when it put down more power with the Saleen SC.
  5. Cali HP Addict

    Anyone tried a stock tune on a big motor?

    Ok everyone, I lied! I didn't make 380/380 that day on the dyno. I made 366hp/370tq with the C&L Street CAI. Adam and I made some further revisions with the C&L racer however there are no official dyno results. Check out this vid that we made and look past 25 seconds to see some donuts at the...
  6. Cali HP Addict

    Want to say thanks! You are a great asset to this community. Very smart and giving in your...

    Want to say thanks! You are a great asset to this community. Very smart and giving in your feedback. Thanks!
  7. Cali HP Addict

    Anyone tried a stock tune on a big motor?

    GlassTop09 I hope that you are making bank tuning! That is some PHD type of info that you are churning out. That injector info was great! I just bought a takeoff fuel rail w/purple stock injectors. I have left some variable input opinion up to Brenspeed such as the injectors and CAI. Let them...
  8. Cali HP Addict

    Anyone tried a stock tune on a big motor?

    Nice write up GlassTop09!! I read the whole thing and understood about 5% of it. LOL.. I am going to read it again and try to learn a bit more for sure. I started out with a 298 stroker and melted a piston on the dyno with a Saleen SC running 15#. Salvaged the crank and 7 rods, put these...
  9. Cali HP Addict

    Anyone tried a stock tune on a big motor?

    Thanks JC SSP! I am probably going to get a custom Brenspeed tune which includes the cmcv in place. I would like to only swap the cold air intake and tune when I have to get a check every 2 years. I know this sounds lazy to many of you younger folk but I have had my fun and just want to enjoy...
  10. Cali HP Addict

    Anyone tried a stock tune on a big motor?

    A good update boys & girls! I put the stock cmc plates, throttle body, injectors and intake manifold back onto my stock compression big bore stroker 322ci with ported big valve heads and comp 300 series cams (no limiters). Re loaded the stock tune from my Xcal 2. Started it up and it ran like a...
  11. Cali HP Addict

    GT 500 Slave Cylinder DR3Z-7A508-A

    What year Mustang are you putting this in brasil?
  12. Cali HP Addict

    Anyone tried a stock tune on a big motor?

    I have been running on an ST Motorsports tune that was made a long time ago. I smog checked this car with the ST tune for at least the last 10 years. Cali just screwed all of us who need "other than stock" tunes for our cars to run correctly. Car puts down 380/380 at the tires on 91 octane. I...
  13. Cali HP Addict

    Anyone tried a stock tune on a big motor?

    Hey all, Stuck in Cali here and I have been running a custom tune on a N/A big bore stroker (322ci) forever. Now, I have to put a stock tune in it to pass the smog requirement. Has anyone done this? By my rudimentary calculations the displacement is approx 15% greater than stock. I also run...
  14. Cali HP Addict

    3V Heads, side mirrors, intake, GT grille, timing chain cover, ect.

    Interested in the timing cover if still available.

Support us!

Support Us - Become A Supporting Member Today!

Click Here For Details

Sponsor Links

Banner image
Back
Top