I knew it was reman, but I went with the motorcraft stock rack DR3Z3504BE, finally came available on rock auto. I’m pretty happy with it so far, didn’t have to get it programmed or anything, plug and play.
Hello!
My 2011 mustang 3.7L has been having a rough idle issue for a while. If it’s getting any pedal at all, it runs normal, good power/acceleration, normal, with mpg up to 30 miles per gallon. But sitting idling, it may idle smooth for a minute, but it’ll get rough, and buzz a bit. It throws...
Tie rod ends were checked and drivers side replaced. Turned out there was a lot of play in the rack, so we replaced it. Less noise now, but there’s still a slight clunk when turning or hitting a bump, may be sway bar related.
Hello!
My steering rack on my 2011 V6 is getting pretty rattly and I figure it’s time to replace it. Motorcraft DR3Z-3504-BE racks for 18” wheels seem to be out of stock across the internet and at any ford dealer I call. Has anybody used any of the BBB industries or other rebuild options with...
Hello everyone!
I was considering replacing my worn out stock steering wrack on my 2011 3.7 V6 with the M-3200-EPAS wrack from Watson racing. My car has 18” stock factory wheels. Can this be done? If so is it a plug and play situation? Also, is this a terrible idea for a every day driver that...