I’m installing an aftermarket fuel gauge in my car and was wondering if anyone had done this? From my research it looks like each sender will have to be connected separately (going to run them to a rocker switch and 1 gauge)
The blue/yel wire is grounded so the yellow(passenger side) and...
I found it on a google search. I’d rather not have anymore gauges. I just need to know the light went out so it’s charging. The pinout I found of the cluster looked like the battery light ran through the canbus wire. I was hoping to run a wire to the engine bay from the light and bypass the...
Does anyone know which wire I need to tap into to get a dummy/battery light to work. I’m swapping a big block into the car and ended up not using the factory cluster and I have a red led I was going to use instead of installing a gauge. If I’m thinking right I should be able to run it off of pin...
I have an 06 4.0 and an HP tuner that I’m using to learn computer tuning. I was wondering how much timing these engines liked? It doesn’t seem to effect total timing no matter what I do it stays around 24-25°. I have upped the MBT tables and still only getting the 25°. When scanning the car it...
I’ll start by saying I’m totally new to nitrous. I traded for a couple kits so I have almost everything I need to add it to the 4.0. My question is how much are you running and what else have you done. I have HP tuner so I can play with fuel and timing some. What are some do’s and do not’s.
I’d like an overdrive so I could continue to drive the car as much as I do.
Yes there are several adapters available to bolt a 460 to a Mod transmission. I was going to build one.
I currently building a 460 to put into my 2006 v6 car. I was wondering how strong the transmissions are. Will they hold up to a 500hp big block. It will be mostly street driven with the occasional drag day. I really like the idea of the 5 spd behind the 460 but would be a lot of work for it to...
I tried to get my scan gauge to read fuel pressure but so far have been able too. I also can’t find anywhere to connect my gauge to check it. I did change the one under the car. The fuel pump duty cycle seems to stay down like it’s not struggling to keep up but would like to be able to see the...
I’ve been working on getting this 4.0 running right. It runs strong until about 4500 and then seems like it hits a wall. You can back out of it so it shifts and it will pull hard until 4500 again. It does surge some after 4500 like it is starving for fuel. I can hook my scan gauge to it and...