Marky73
Junior Member
Ok, so I have posted this on multiple Mustang sites. But thought everyone could share with someone they know who may be able to help. Here is my Post:
I just bought my 2006 Roush Stage 2. With only 20,800 Miles I knew the top was not working when I purchased it. The day I looked at the car I lowered the top with the switch it worked fine. Then absolutely nothing when I tried to raise it back up. I do not hear the relays in the fuse panel clicking when I press the switch up or down. I do hear a clicking in the drivers door when I press the up or down button and occasionally the passenger side window will go up when I press the top button then, it goes back down when I press the opposite button.Here is what I have done so far.
1.) Serviced the pump with ATF
2.) Swapped the relays (bought new ones and tried them too, nothing) they do NOT click
3.) I pulled relays and checked for power on the correct slot, I am getting power at the relays, but they do not click
4.) The 5 amp fuse in the passenger side panel was blown and I found corrosion on the entire panel, I removed all plugs and fuses, cleaned with QD Elec cleaner and brush to remove green and white corrosion. Applied di-electric grease to all connections and replaced the 5 amp fuse.
5.) Checked for power at the hydraulic pump/motor, I am not getting power when I press up/down button
6.) Applied 12v directly to the hydraulic pump/motor and nothing happens.
I am so confused by all of this. Power at the relays but no clicking when button pressed. Swapped with brand new relays and same thing, so I think relays are good.
No power at the plug for motor, and direct 12V to the red or yellow pin does not do anything.
7.) I replaced the convertible top hydraulic lines, since they were leaking. While I had the lines disconnected I manually raised the roof. The windows would still not go up. Then a few days later, they did go up and down. Then stopped working again.
I just bought my 2006 Roush Stage 2. With only 20,800 Miles I knew the top was not working when I purchased it. The day I looked at the car I lowered the top with the switch it worked fine. Then absolutely nothing when I tried to raise it back up. I do not hear the relays in the fuse panel clicking when I press the switch up or down. I do hear a clicking in the drivers door when I press the up or down button and occasionally the passenger side window will go up when I press the top button then, it goes back down when I press the opposite button.Here is what I have done so far.
1.) Serviced the pump with ATF
2.) Swapped the relays (bought new ones and tried them too, nothing) they do NOT click
3.) I pulled relays and checked for power on the correct slot, I am getting power at the relays, but they do not click
4.) The 5 amp fuse in the passenger side panel was blown and I found corrosion on the entire panel, I removed all plugs and fuses, cleaned with QD Elec cleaner and brush to remove green and white corrosion. Applied di-electric grease to all connections and replaced the 5 amp fuse.
5.) Checked for power at the hydraulic pump/motor, I am not getting power when I press up/down button
6.) Applied 12v directly to the hydraulic pump/motor and nothing happens.
I am so confused by all of this. Power at the relays but no clicking when button pressed. Swapped with brand new relays and same thing, so I think relays are good.
No power at the plug for motor, and direct 12V to the red or yellow pin does not do anything.
7.) I replaced the convertible top hydraulic lines, since they were leaking. While I had the lines disconnected I manually raised the roof. The windows would still not go up. Then a few days later, they did go up and down. Then stopped working again.