T

Profile posts Latest activity Postings About

  • Got my engine to start but dies. P0685 code along with p2111 and p2104. At c110 connector 2 wires not connected yel blue strip power and green orange strip other side 3 wires red . black. And grey. Power at 3 pins of relay with c175b connected. Any thoughts?
    Hey, Im swapping a 4.6 into a v6 donor car and im not sure whether or not a 2010 harness will work. Im buying engine/trans/harness/ecu-pcm/... pretty much everything i need for the swap. Im planning the pick up for tomorrow. Would you have any insight ? If youre able to let me know asap you could be saving me a lot of moolah. Thanks, Blake
    T
    TexasBlownV8
    Generally, it's easier to get a year-compatible PCM and engine harness for your car (2005, 2006, or 2007-2010).
    However, any harness can be made to work; there's a few circuit differences, mainly relating to cruise control and a/c, but for the most part, the cross-years can work together, with some modifications.

    Feel free to reach out for more questions.
    Good Morning,
    New member here.
    I hope you don't mind me asking a question. I saw your name when it came to wiring fog lights.
    I have a 2005 V6 and I'm putting fog lights in.
    Can I use the factory lights\fogs switch from a 2008?
    I found it at the local parts yard. I wasn't sure about the pin outs on the connectors.
    Thanks,
    Bill
    T
    TexasBlownV8
    Sorry, Bill, just saw your question. You can use any 05-09 GT stock light switch, or even a pony-package v6 with fog lights. In addition to the switch, you'll need to do a little more wiring to get it to work like stock, but it's not that hard to do.
    ..continued..
    T
    TexasBlownV8
    Essentially, the 'foglight-switch' function is programmed/wired into the SJB, such that the foglight control is not present between the switch and foglight relay in the BEC; so you can run a wire from the light switch to the BEC to trigger the proper relay; and then on the switched-side of the relay, there will already be +12v fed in, so you just need to run wires to the lights;
    T
    TexasBlownV8
    ..adding a wire-and-pin to the BEC connector underneath is the cleanest way to do that; I have that part of a GT foglight harness if you need one.
    Feel free to reach out for more questions.
    Mike
    Sorry, Mike got in late last night and found out all my messages have been erased? Could you send me your email address again please.
    Lol, just saw this. Nice pic! Indeed the 'tides have turned', to the point where I can hardly race the car there anymore, just too dangerous for the power. And I sold the supercharger a couple years ago. But just picked up a turbocharged '06 4.0L; now I have 2 toys to play with.
    I'll get back out to TAD eventually, swing by and say hey.
    ah how the tides have turned in the last few years

    hey man did you do an engine swap in your car? if you still have the supercharger how much would you sell it for (if you want 2 sell it) , im in dallas, tx. thanks, Ryan
  • Loading…
  • Loading…
  • Loading…

Latest posts

Support us!

Support Us - Become A Supporting Member Today!

Click Here For Details

Sponsor Links

Banner image
Back
Top