Mr. Q
forum member
So, I'm using my HF DA with CG VSS to do some mild correcting and using CG yellow hex pad with about 5-10lbs pressure and then this happens. What did I do wrong? I saw some smoke and immediate stopped, accidentally lifted a but as it was slowing down and the middle came flying out. I'm new to this so I'm not sure what I did wrong. Ih, also at the time, there was no direct sunlight on the part of the car I was working on.
Also, I have these ugly spots, looks like hard water spots. Any hints as to how to get rid of them? Thanks
Sent from my SM-G900V using Tapatalk
Also, I have these ugly spots, looks like hard water spots. Any hints as to how to get rid of them? Thanks
Sent from my SM-G900V using Tapatalk