Hydraulic lash adjuster

While putting my heads together and living everything up I realized my hands where quicker than my eyes while taking the heads apart.

When installing the hydraulic lash adjusters does it matter the orientation of the oil inlet hole on the body of the adjuster?

I installed them so the hole faces the main head gallery feed hole. Lower intake @ 12 o'clock and the upper exhaust at 6 o'clock.

Or do the adjusters end up spinning in the bore and I'm completely over thinking it?


Sent from my iPhone using Tapatalk

they will rotate in the bore once pressurized, it doesn't matter bubba

Awesome. Thanks for your reply.


Sent from my iPhone using Tapatalk