Whats your winter mod list look like?

Gonna put it on a diet:

Rear seat deletes (already did):



Stock 2010+ rear seats weight a total of 37lbs will all the brackets included but no the seat belts. The delete weight 8lbs total.

Going to relocate the 43lbs optima to the spare tire well.

BMR a-arms

Lighter wheels that are 5lbs lighter at each corner.

Aftermarket seats ie. Corbeau are 27lbs plus 10lbs for the slider/brackets replacing full power driver/passenger seats which are about 60lbs each.

hopefully selling the 08.

for the 12, maybe a smaller pulley and boost-a-pump. not likely until i get new oil pump gears though.
most likely gonna change the tail lights and mirrors though.

Got a forged short block built ready to go in
8 rib pulley kit to spin my DOB kit for 16-18 psi
Eaton true trac and 3.55 gears to replace Yukon dura-grip and 3.73 gears.
Probably throw on a off road h-pipe for good measure

BMR k member
BMR rad support
Steeda UDP
Motion charge deletes.
Steeda clutch line
Steeda jacking rails
Shifter (MGW or Barton) ordered both waiting to compare.
Motive 3:90 gears
New plugs still researching
07 premium GT manual Grabber orange

Winter mods? As little as possible because I have to work outdoors.

14" brakes, FRPP hubs and front control arms, and a few other odds and ends when the weather decides to stay warmed up without precipitation for more than a day at a time. Springtime mods already.


Norm

Mine is just about complete. New McLeod RST Twin disk clutch and clutch line, Termec XL Magnum trans, New alum drive shaft, Eaton True Track, FRPP3:73, Strange axles with C slip eliminator, Alum rear cover.
Now to finish up with the Drive shaft safety loop, FRPP front hubs.

Winter is over

o2sys said:

Winter is over

Click to expand...

I sure hope so.....