pass1over
I like it LOW
Had a stator burn out on my Honda 3000 recently. Bought a new one and got the unit all back together. But ran across something odd. The key activates the starter and it turns the motor over, but I get no spark and the motor never fires. However, if you pull the cord, it fires right up.
I only see two wires to connect to the starter, and they're both connected. I never unplugged anything from the ignition coil. I cannot find anything else that's unplugged. I have both of the grounds on the harness hooked up to the black and the frame (even tried tying them together).
Is it a bad switch?
I couldn't find specs on gaps, so is my ignition coil too far away from the rotor possibly?
Don't have access to the serial, but it's a Honda eu3000is bought back in like 2005-ish
I only see two wires to connect to the starter, and they're both connected. I never unplugged anything from the ignition coil. I cannot find anything else that's unplugged. I have both of the grounds on the harness hooked up to the black and the frame (even tried tying them together).
Is it a bad switch?
I couldn't find specs on gaps, so is my ignition coil too far away from the rotor possibly?
Don't have access to the serial, but it's a Honda eu3000is bought back in like 2005-ish