Correct, I use a vice and a half of a bobby pin.
WRT "vise" v. "vice" and mounting it on the table, TMI.
Here you go
2. NOTE: Oil pump must be held against the cylinder block until all bolts are tightened.
Tighten the fasteners in the sequence shown in 3 stages:
• Stage 1: Hand tighten.
• Stage 2: Tighten the bolt (1) to 10 Nm (89 lb-in), the stud bolt (2) to 25 Nm (18 lb-ft), the bolt (3) to 10 Nm (89 lb-in) and the stud bolt (4) to 20 Nm (177 lb-in).
• Stage 3: Tighten the bolt (1) an additional 45 degrees, the stud bolt (2) an additional 75 degrees, the bolt (3) an additional 45 degrees and the stud bolt (4) an additional 60 degrees.