InFinite
FNG
Hey folks–
I believe this is my first thread on this forum, so I apologize if this question has already been answered (I tried using the search function with no luck).
I have a 2005 Mustang GT that I am performing a TREMEC Magnum XL swap into. If you're familiar with this type of swap, you'll know that the swap requires a new (or modified) driveshaft in order to complete it.
I've searched everywhere on this forum and a few others, and for the life of me, I can not find the measurements for the length of the driveshaft necessary. Does anyone know the measurements from the center of the front U-joint to the center of the rear U-joint?
Or from the front of the slip yoke to the rear of the pinion flange? If anyone has this information and wouldn't mind sharing it, I would greatly appreciate! I am looking to provide a local driveshaft shop with these measurements so that they can fabricate a driveshaft for the swap.
I believe this is my first thread on this forum, so I apologize if this question has already been answered (I tried using the search function with no luck).
I have a 2005 Mustang GT that I am performing a TREMEC Magnum XL swap into. If you're familiar with this type of swap, you'll know that the swap requires a new (or modified) driveshaft in order to complete it.
I've searched everywhere on this forum and a few others, and for the life of me, I can not find the measurements for the length of the driveshaft necessary. Does anyone know the measurements from the center of the front U-joint to the center of the rear U-joint?
Or from the front of the slip yoke to the rear of the pinion flange? If anyone has this information and wouldn't mind sharing it, I would greatly appreciate! I am looking to provide a local driveshaft shop with these measurements so that they can fabricate a driveshaft for the swap.