skwerl
tree hugger
I recently purchased a pan hard bar, upper and lower control arms and the lower relocation brackets (anti hop kit). Today I started the installation and got everything in except the UCA. I don't have a 47mm Torx and neither does the local NAPA.
Anyway, my minor issue is regarding the grease nipples on the pan hard bar. I installed the unit as instructed with the adjustable end on the axle, but when I went to grease it I was unable to access the grease nipple. I had to unbolt the passenger side of the bar and swing it down in order to angle the grease fitting so I could grease it. I realize it's only a 'one pump per year' deal but perhaps you might want to have the engineering department actually stick one on a car and try it out.
The good news is that everything seems a lot more solid back there now and I'm looking forward to another new best ETA tomorrow night at the track. I'm launching fairly well and this should shave a tenth off my 60' I hope.
Anyway, my minor issue is regarding the grease nipples on the pan hard bar. I installed the unit as instructed with the adjustable end on the axle, but when I went to grease it I was unable to access the grease nipple. I had to unbolt the passenger side of the bar and swing it down in order to angle the grease fitting so I could grease it. I realize it's only a 'one pump per year' deal but perhaps you might want to have the engineering department actually stick one on a car and try it out.
The good news is that everything seems a lot more solid back there now and I'm looking forward to another new best ETA tomorrow night at the track. I'm launching fairly well and this should shave a tenth off my 60' I hope.