Roush s/c install/knicked radiator

5tangiac.0 · Dec 29, 2016

I knicked the radiator somehow. I am talking pin hole size. Thoughts? Anyone successfully repaired one?

Also how can I torque the crank bolt down to spec after the ati install with an automatic.

Sent from my iPhone using Tapatalk

5tangiac.0 · Dec 29, 2016

Buying a new radiator. Any ideas on how to stop the motor from turning over when torqueing the crank bolt?

Sent from my iPhone using Tapatalk

JUSTA3V · Dec 29, 2016

Drivers side of block at the back where it connects to the tranny.

There is a rubber plug. Pull it and jam a screwdriver in there against the flywheel / flexplate

5tangiac.0 · Dec 29, 2016

Will try that tomorrow. Thanks! Wasted half of today trying to find a longer bolt for the ati install. Wound up buying all 3' of all thread for $50

Sent from my iPhone using Tapatalk

travelers · Dec 31, 2016

When I installed my ATI I used a strap wrench to hold it. Worked good. This is basically what I used

https://www.ridgid.com/us/en/strap-wrenches

Roush s/c install/knicked radiator

5tangiac.0

forum member

5tangiac.0

forum member

JUSTA3V

Moar Throttle!

5tangiac.0

forum member

travelers

Senior Member

Similar threads

Latest posts

Support us!

Sponsor Links