Flat black oil filter relocation kit

New kits in stock ready to ship. Featruing no leak an lines and fittings from Fore, this kit has everything you need to relocate it down to the filter.

Complete Kit includes:
-Aluminum spin on low profile engine adaptor and filter relocation adaptor with 1/2 npt ports with flat black finish.
-4 black 1/2 npt to 8an male to male fittings
-4 black 8an swivel hose ends
-6ft of 8an AQP Kevlar/Nomex black braided line (3ft per line)
-Motorcraft FL-1A larger capacity 3/4-16 thread oil filter
-Mountings screws for filter relocation adaptor
-Fittings come pre-installed with Locktite 567 thread sealant and an hose ends installed
*Kit adds aprox. 1/2 to 3/4 quart of oil to your system increasing oil capacity

$169, free shipping in the cont US!

ttt.

ttt.

Bump.

Will this work on my 2002 F150 with the 5.4 Triton motor? The stupid filter placement over the front cross member is a total PITA with the stupid drip tray that diverts the oil runoff in two directions. I need a sheet of plywood, two drain pans and a garbage can lid to catch all the drips when I change my oil.

What is the stock oil filter thread pitch on it? If its 22mm x 1.5, then yes it will fit. I know it works on 99-10 4.6 but havent looked at the 5.4. If it's different I can put together a kit specifily for it as well.

Same filter as the Mustang, just a different location. I was worried about how it fits in there.

Yeah if its the same fl820s or whatever then yes this kit will fit.

Ttt

ttt.

Bump.

Dumb ass question but I am in China and can't see my car. i am guessing I can access this in the new location without removing the fender well plastic ?

Thanks
Andrew

Yes.

In stock.

TTT.

Jeremy want to add this to my other shipment

Bump.

Jeremy got my kit and everything is setup, except the lines. Should I connect them in to the in or in to the out and out to the in?

Thanks

tbrock said:

Jeremy got my kit and everything is setup, except the lines. Should I connect them in to the in or in to the out and out to the in?

Thanks

Click to expand...

Goes in to out and out to in from each adaptor.

Any pics of it installed? Very interested but I'd like to see where it gets mounted.