Recent content by 07SGT4743

I also had the DOB manifold with the 122 blower on my Shelby GT. I used a stock GT500 (cheap) brace plus the lowering engine mounts. They weren’t hard to install and I had no issues.

Hi Johnny, I have a set of Steeda rear lower control arms poly and heim joints p/n 555-4406 off my ‘07 Shelby GT that I sold. Approx 15k miles. If you have any interest, make me an offer you feel is fair. They are just sitting in the garage taking up space. I had these combined with the Steeda...

I have an Eibach 25mm 3 way adjustable rear bar. P/N 35129.312. Red powder coat with the billet links. Listed for $405 on Strano’s site. Looking for $200.

Saw your wheel hop post and agree with the others. I went poly upper arm, spherical bushing on the rear axle, billet poly / spherical lower arms, relo brackets. No hop, slight increase in road noise. I’m selling the car and am doing a partial part out. If you have any interest, I’d sell the...

Not specifically a Bullitt intake tube, but I have a Steeda Intake Tube available. It’s the big plastic elbow with blue silicone hose ends. P/N 555-3130. It sells for $115 on Steeda’s site. If you’re interested, pm me a reasonable offer.

I have a set installed in my ‘07 Shelby GT. I don’t daily drive the car, but do drive it on some pretty long trips to autocross events. Overall, I’d rate them at about an 8 out of ten. On long trips, I feel I could use a little more support for my lower back. The width is comfortable, but...

Not sure whether this suits your needs, but I have a set of Steeda underdrive pulleys (balancer, water pump pulley) that I’d sell for $135 shipped. Approx. 15k miles, no winters, great shape. Let me know if you’re interested.

I'll have one available in about a week. It's roughly the same size and shape as the radiator overflow tank. Can't find a part number in it, but it looks just like the Ford tank except with the proper inlet / outlet. It came with a D.O.B kit I just purchased and I decided to use a different...

Hello, Question on the Whipple system. I have an '07 Shelby GT with the TR3650 5 speed (recently rebuilt to stock) with a dual disk clutch and T2R rear diff. Car is street driven and used in national level Autocross competition. No road racing, no drag racing. Do you think the transmission is...

I have a set of Maximum Motorsports camber plates it you are interested. Looking for $125 shipped. Good condition ~10k miles, no noises. Went to a coil over setup utilizing different mounts.

PM sent.

PM sent.

I've done this job on two different cars and found it was pretty straight forward. Don't use the larger gun type soldering irons, you want to use the smaller pen type irons. The boards are fairly fragile and expensive to replace. There are kits available that include the motors, iron and the...

Agree that you don't need to drop the driveshaft. Installed an MGW in my '07 over the winter and I found that simply loosening the transmission support gave me plenty of room. By the way, I love the way it shifts.

Maximum Motorsports, Ground Control Suspension and Vorshlag all offer a set of plates for your car. I've used the first two without any issue; no noise, do not slip, good range of adjustment. I don't have any experience with the Vorshlag plates, but they appear to be extremely well made.