Recent content by Born To Run

Power steering I did replacement myself using Don Bowles (The Coal Digger) home shop yesterday in Bradenton. Had a car hoist & all the tools I needed. Big thanks to Donnie Bowles Jr for making this happen.

Does anyone have a PDF on removal of power steering pump & pulley for 2005 GT. Search has nothing.

Need repair ASAP in St Petersburg FLA My power steering pump is leaking badly from the seal & noisy as hell when wheel is turned. I am picking one up tomorrow morning. Does anybody have the ability to re & re this for me or know of a shop that can do it. Ford dealer is to busy as are other...

I am thinking about re installing my front factory sway bar. I noticed two holes up on the strut for the end links. Which hole do I put it in? The hole in the front or the hole in the rear? I removed it over 10 years ago & don't remember which hole it was in back then. Thanks Randy

Che brace I have one.

Knock sensors I removed mine physically form the stock longblock. Locked timing at 20 degrees. I seen some Air inlet temps spike at the 1200' mark in the 200F range & beyond. FI running 12-15 psi & beyond in some cooler air. Had a tune when I got in trouble wth 25 degrees of timing. I made...

Over heating Thermostat in upside down backwards?. Turn it over & try it. Always boil water on stove & verify thermostat opens before installing.

Saleen shifter spacer Found it !! See pics.

Shifter block I may have mine still.I will need to look,it's been along time since it was used. Give me a email Tuesday [email protected] to remind me to look. Randy

Has anyone installed one of them on a Tremec 3650? Does it make a difference? Pros/Cons Thanks

Autolite They one with factory gap. From the factory? Not sure,probably 35-40. I can measure for you,or I can gap them to your spec if you like.

Autolite 2 sets left.

How do you check a coil on plug if its good or bad when it's out of the car?? OHM test,resistance??? Special tester ?. Thanks Randy

Autolite Paypal acc is [email protected] Thanks Randy

Trans parts Check with Steve Poe on here,he has lots of hard to find little parts most of us throw out or loose by accident.I think he is in Cincinnati.