Recent content by datmbn

My car is at original height and with original rims 18 inches (235x50 r18) and when you look at the car you can not see that the rear axle is offset but it looks straight and nice, but if you actually measure, you see that the shaft is offset by about 8-10 mm, but you can not see that. The...

Slipping gearbox check the oil level in the gearbox if there is too little oil in the gearbox, the pump can suck air when turning or braking/accelerating or driving on a slope.

C2280b 39 is just an pass through to C2280c 29 so you kan make an external conection of this to to make it work

the one that sits in the door lock inside in the door

go to the thred in DIY High beam in foglights

The safety switsh to the fuel pump, located at the left of the driver's footwell, may have tripped Have you tried to reset it

You may need to do a window reset, just like on the door windows when they are out of sync

Have you tryed to disconekt the generator

I find it rather strange that no one seems to have investigated the causes of the problem. Some cars work well, so the problem must be solvable !! I've looked at the problem, and found both cause and solution (I think) The biggest problem with finding a solution is that the problem consists of 2...

if you find multipel fuses that has draw than it is probebly an relay that not relases

The alternator is high on the list get an alternator for 2010 they are more durable

No that one is for recirkulation of air the one you are looking for is the lower one on passenger side of the heat box This one dont have an leveling arm but just an hole with splines .

The easiest is to take a screwdriver and jump between the two positive poles on the starter motor, just make sure that the gearbox is in P or N position first.

does it crank if not make sure you monted the starter corekt as well as the eartwire at the motormount

I have done it 2 times already and ar upp for the 3 time when the car returns from winter hibernation I used cheep aftermarket ones that dont last but this time i using Motorcraft hopfully they last longer. I think that the potensiometer that tells how far the swingarm has traveld goos bad and...