I guess it would have to do with how much I can bring in with the covers or the whole seats. I am planning on this hopefully funding at least two front seats and the brackets for them. I would like to sell in my area as well if I sell the whole seats and rears. I will look up other sales too.
Not sure if this post goes here but I will give it a try. What should I ask for my Leather power front seats and the rear leather seats or seat too? I am not sure were to start with this. Thanks for any help!
I was wondering the same. I don't have a supercharger but my CAI is due and I was wondering if an AEM would be better than the replacement or just clean the original? I have heard great things about the AEM.
I went to a Hurst just a month ago and love the new short shifts but I have the same side to side movement as well and did not in my stock one. Its breaking in nicely though and getting a little more easy to move around. I will check my mine this weekend and report back. The only reused part...
Making a point to not close doors on other mags that have good tech in them. I get about 10 to 12 rags a month. In the end, If MM&FF, 5.0, and CycleWorld make it, The rest can hold me until the next month when they those rags make it again. Or a good fix of this forum helps too.
I saw that in GM. It was a good article. carbon fiber has few limits if you know how to deal with it. I get a lot of mags. because each have there own really good tech. I even get Sport Compact Car. Most of the mag. is trash but the tech is really great. So is Turbo, Cycle World, and a few...
Thank you for the kind words about my service. I am healing well just a little board. I will check around for Sintra in my area because to have two sheets sent to the house would cost in shipping just over what a single sheet costs and that is pretty expensive. I can see why the custom APR...
908ssp and Chris, Thank you for all the info on aero and I will be reading the book. I am currently a wounded Soldier at Walter Reed in the DC area. I worked on electronics/avionics and airframe and powerplant on helicopters. I also build custom guitars as a side job. Before the Mustang and...
Thanks 908ssp, The splitter looks great. On the difusser you cut the Sintra to make the three channels and then gorilla glued them at making sure the panel against the rear of the car has a seven degree angle? Also, Besides APR, Are there a few good companies out there making good wings? I...