Does anyone know the pin outs for the stock Ford speed sender? (3-wire)
I use a volt meter here is what I got
One is ground
One has 4.99 volts
one has 11.8 volts
any one know what one is the signal wire? (4.99 volts wire or the 11.8 voltwire)
sorry
A repair kit will not help
I need the other end (the connector the sensor has on it)
a Tremec XL uses a 2 wire speed sender
The stock Ford is a three wire sender
Thanks,
I have all those parts and the manual and emaied Dakota
But it looks like I need to cut the connector off of the stock wiring harness and run those wires to the Dakota box (did not want to cut the stock harness)
That is all well and good but short of ohm-ing all the wires on the stock...
I have installed a Tremec Magnum XL in my 2013 Mustang
Does anyone have a wiring diagram for the Dakota Digital SGI-5E speedometer converter unit?
The instructions and adapters they included in the kit are Very very generic....
I have looked on the web but have not found anything.
and / or does...