Recent content by groundpounder

Take the thing that looks like an upside-down penguin. Using your right hand orientate it so that its head is to the east. Then with your left hand use some vegan personal lubricant to gently grease your oring. Once it is lubed to mil-spec 11-56-54378, place it on the southeast protrubence if...

I'm going to be doing a DOB kit this spring. I won't be forging the motor so I'm going to be limited to the 450 rwhp. Do I need to run the more expensive 91 octane that I'm currently running on my N/A tune? My gut says I should run higher octane but what's the science say on it. Opinions?

Are these the "street" or the "street & strip" ones?

8 years, 2 months, and 21 days since this thread was active. Deader than dead. But hope springs eternal!

Motorcraft YH1865. $38 at Amazon.

The one you need to replace is the one located behind the gauge cluster. Which means pulling the console, left knee panel, lower dash panel (under steering wheel), then pull cluster. Then use a combination of 1/4" extensions, elbow joints, and wobble sockets to get the two screws out. I did mine...

No longer for sale.

http://www.silverhorseracing.com/SHR-Flush-Mount-Quarter-Vent-Louvers-pair-UNPAINTED-for-2005-2009-Mustang.html Down at bottom under Installation Time.

I think SHR actually did a write up on how to paint these. Go to the product page and look towards the bottom.

Bluetooth OBD adapter and Torque Pro (Android only). I love this set up and use it on my Mustang, diesel F350, wife's Sentea, and friends' cars to help them out.

I tried, not allowed for some reason. Probably because you are a new member.

Still available.

I have a 13/14 HE for sale in the FS section.

I'm in Las Vegas and moving to Phoenix. The problem with selling these is shipping. Everybody wants a minimum of $75 to ship. USPS priority mail at least gets it there in 2 to 3 days. I paid $325 for it when I got it locally. I'm just trying not to lose to much on the sale.

Bump. Would rather sell than take with me when I move.