Recent content by Jrd761

Looking to get it tuned. I've seen on other boards that Wild Pony has been around since about 2006. The guy was pretty helpful in getting my car back up and running, just don't know about his tuning skills.

Sorry, my bad! Hopefully someone can move it.. Thanks!

I'm going to get my car dyno tuned this week.. Can anyone recommend a good dyno tune shop in the Southern California area? And, a ballpark price of what they charge?? I'm in Santa Clarita, so the closer is better. I've heard there's a place here in Santa Clarita called "Wild Pony...

Got it running! I went to O'Riley after noting the new Mass Air Flow Sensor they gave me didn't look right (it looked used.. Like maybe someone had returned it). I exchanged it for a brand new one, popped it in and it ran like a champ! I've been driving it around running errands all afternoon...

I don't believe it is extended. I modified it when I did the IAT relocate kit 5 months ago, but all the wiring looks fine. Checked all the fuses, they're good.

Everythings tightened up. All clamps are tight and everything is on how it's suppose to be.. The only vaccum line I unplugged is plugged back in (goes from the T at the fuel pressure regulator to the "blow off valve" (not sure what the actual name is)). The only connector I disconnected was the...

Nope. It has been running the Brenspeed tune for the past 5 months / 5,000 miles without any problems. No check engine lights, has been running pretty good.. Just started doing this after the S/C Swap

Thanks for recommending I come over here! The vortech v-2 was installed on the car before I got it. I'm not sure what tune it had (if it had one at all), but I went and got a brenspeed tune on it. I know my brother found out what injectors it had, I just can't remember what they are now. The...

Just got home from work and tried starting the car with the new mass air flow sensor.. and the car wouldn't start. Which is weird, yesterday it would. But, it starts when the mass air flow sensor is unplugged. Brenspeed is saying that the two superchargers are almost the same and that there is...

Basically here's what's going on. I have a 2005 Ford Mustang GT. It had a Vortech V-2 Supercharger on it, but somehow the impeller shaft became bent causing the impeller to rub against the housing of the supercharger. I replaced the supercharger with a freshly rebuilt by Vortech (or so...