Block is sold....
Thank you very much much painterboy39. You are a great buyer. Would deal with him anytime. He even sent me a check after the sale to help cover unseen shipping charges.
Looking for 3v engine torque specs.....
factory Crank, mains, side bolts factory bolts
lightwieght Manley I-beam rods with arp studs and nuts
Factory heads with torque to yield, and studs
Thanks!
Someone had removed the plugs prior to it being torn down this year. Which resulted in a little suface rust in cylinders. But the block need to be honed anyway. I has all mains and bolts. And rear seal. I'm not sure about the side bolts though.
You may not want to cut the corners so square. If you put enough round into them it would be a lot easier to put trim of some sort on it later. May also look better and help keep water seepage out.