Recent content by richh789

Thanks, I honestly didn't even dig into it yet. New to me and wanted to make sure I had all my bases covered before pulling it apart and scratching my head. Sent from my XT1254 using Tapatalk

How would you determine which can wire goes to which if there's two of them? That entire system blows my mind. When the time comes I might pick your brain for the setting up of the ac compressor. Need to have someone fabricate hoses then I'm going to see if I can figure out how to make it fire...

Is that something that someone who does dyno tuning could do? It has Lund Tunes in it now but wanted to bring it to get live dyno tuning done to make sure it's 100% Sent from my XT1254 using Tapatalk

Lito,The guy who did the motor swap was telling me you were very knowledgeable on this subject..... He got alot of info from you. My question is, if the engine has a frpp control module, where to you hook up the can wires? Same place as the two wires that communicate with dash? Sorry I'm...

Do you have your canbus wires hooked up or just the ground, power and Trigger wire? Sent from my XT1254 using Tapatalk

looking to do this swap myself. I recently picked up a coyote swapped 06 that has a write-up on here. Car came with the BMR tubular K frame, and a epas rack (not installed). Going to order the wiring harness which seems pretty straightforward except for the can bus wires. I'm trying to wrap...

Let me try this again. Reduced from 30 seconds down to 8, unfortunately.http://cloud.tapatalk.com/s/5a86009c65c33/TRIM_20180215_164234.mp4 Sent from my XT1254 using Tapatalk

I got to figure that one out. What I clicked on to post was a video Sent from my XT1254 using Tapatalk

Little bit of audio for your listening pleasure Sent from my XT1254 using Tapatalk

Yes, I'm pretty sure he is also, he sent me a bunch of screenshots from here. He owns PIK customs. Sent from my XT1254 using Tapatalk

Any updates? Sent from my XT1254 using Tapatalk

Any updates? Sent from my XT1254 using Tapatalk

I've had several Fox body Mustangs in my teens and twenties but been out of the Mustang scene for the past 10 years or so after having kids. Have a couple of built rock crawling Jeeps (triangulated 4 links, 1-ton axles, motor swaps...), but been having to itch for something that looks as good...