Search results for query: *

  1. L

    Pilot bearing stuck

    I'm gonna go ahead and suggest that bread is a poor man's 'kind of hydraulic' action, you're better off trying a much denser hydraulic medium such as grease. Pack it in, get a tight fit rod on it, and give it a few good whacks. The tighter the fit, the less grease you'll get in the face (wrap a...
  2. L

    LITO where are you???

    Testify!
  3. L

    On3 fuel hat install

    You don't need to get a hand in there. Hang/hold it with the spout opening an inch or so below the lip and thread it with finger/thumb, snug it with the wrench, drop it the rest of the way in, viola.
  4. L

    On3 fuel hat install

    Can't you simply remove it to insert the unit into the tank and then reinstall it. Seems like you can easily get a wrench on it after it's past the lip.
  5. L

    Speaker Only Upgrades

    Hold my cosmo
  6. L

    2007 Mustang GT engine swap or build current motor

    There's no replacement for displacement
  7. L

    Aftermarket Bluetooth stereo- microphone placement

    I'm pretty sure it's in the overhead light console, factory, in the vert that I have.
  8. L

    2011 Gt, can I disconnect speedo drive easily and still drive it?

    So you really are planning on putting 2000 km of additional mileage on the car. You just don't want anyone in the future to know about it. Have I got that right?
  9. L

    My amateur photography

    True enough re framing vs expensive equipment. I shot these on a lark with whatever galaxy phone was current back in 2006.
  10. L

    4.0 to 3.7 V6 swap

    I can't remember the details (ie, if it resulted in a no start until i rectified it), but i did a similar swap (80% of the guts of a crashed 2013 or so into a 2011 - coyote to coyote), and the RCM from the 2013 was crash locked. I had to drop it off to 'a guy' who had an interface that allowed...
  11. L

    No Heat

    Sounds like a plugged heater core
  12. L

    4.0 to 3.7 V6 swap

    A shot in the dark, is the clutch sensor plugged in?
  13. L

    Flat spot eliminators

    Yea, any flat spots I've 'noticed' have been forgotten after a mile or two. No experience with em but i wouldn't bother.
  14. L

    Race Red 2012 3.7 Mustang - G-Daughters Daily.

    If you have the right tools... you could try to fix it yourself https://www.reddit.com/r/CrazyFuckingVideos/comments/10dkrtw/using_a_dildo_to_fix_a_dent/?utm_source=share&utm_medium=android_app&utm_name=androidcss&utm_term=1&utm_content=share_button
  15. L

    New parts still a "Clunk" over bumps..

    Make sure your fender liners are pinned in snugly.
  16. L

    S650 REVEAL

    Epic's unreal is a fantastic development platform. Good stuff.
  17. L

    Battery options/debate

    Bolt schmolt, just squeeze a pair of vise grips over the clamp, done.
  18. L

    Car rental

    Could have just told her to stay in her lane... [emoji16]
  19. L

    1st gear rattle

    Are you sure it's the trans and not just a cat heat shield that broke a spot weld and is vibrating at just the right harmonic?
  20. L

    Tuners?

    Can't wait to hear about the improved tune you receive after you run a few pulls on the 93 race tune and provide the data logs to bama. Could be groundbreaking.
  21. L

    best way to tackle engine removal ?

    As mentioned, the mounts are standard. Although Ford recommends the leveler (along with every other specialty tool listed in the shop manual), i didn't find it necessary. Using chain straight to the bolts/hoist hook, along with a little push n pull here n there, worked just fine for me without...
  22. L

    Wes Duenkel's S197 Modification book

    Buy it, somebody has to keep the economy chugging along.
  23. L

    An Electric Car Worth Looking At!

    I put so few miles on anything these days that i could only recoup the investment in electric if it were a stand-up scooter (and don't think i haven't seriously considered it along with some modding ideas to keep it interesting as a grocery getter).
  24. L

    08 4.6 Misfires

    Coil on plug, directly, versus remote coil with spark plugs wires.
  25. L

    14 GTCS project...

    'wifes hair dryer' - riiiight... [emoji16] Looks much better. I can relate, bought a year one Hemi charger back in 06, and the look of the rub rails on the doors bugged me. Three weeks old and first 30° (C) day at work I grabbed my pass-card and pulled them off in the parking lot at lunch...

Latest posts

Support us!

Support Us - Become A Supporting Member Today!

Click Here For Details

Sponsor Links

Banner image
Back
Top