Search results for query: *

But cycle the electrical system and it starts... I’m having a hard time figuring out where to begin… I got in my car after it was parked for about 2 hours and it cranked but did not start. So I cranked it again, and this time held it in the start position longer than I normally do and the...

I ordered a JLT oil separator and need to extend the short line pictured below to reach my KB intake. Anyone know a source for the plastic "hose" Ford used and where I might find the connector in case I can't reuse the one I have on the JLT provided line? I'd like to make the whole thing look...

Leaving a local cruise I got on it a bit and was rewarded with the typical rush of FI motivated thrust. Everything was right. Drove a few more miles, came to a red light and on green tipped into boost and the car fell all over itself and the CEL/MIL came on flashing. Engine vibrated the whole...

I've read a lot on these two codes now, but still not sure about how to resolve it. On occasion after start-up, before the engine is fully warmed up the engine will go rich and idle roughly. But it only lasts about 30 seconds and corrects itself - no codes are thrown. Today on the way home...

I recently did a complete install of BMR's front-end components. I'm very pleased with them, but I have an issue with the Whiteline sway bar I installed. They ship with two sets of bushings, one for the 2005-2010 cars and an second set for the 2011+ cars. The bushings are quite larger for the...

Okay, so I've been at this for a little while. I want to have some custom fender emblems made up that look just like the GT emblem on my '08. Problem is the places I've visited that do CNC work want about $280-360 for a pair in stainless. Ouch! So I designed a set in AutoDesk123 Design. The...

Seems they're creeping around... Not too long ago I started to hear a hissing sound from the driver side kick panel during start up - actually sounds a bit like a fuel pump prime (really, I chalked it up to the emergency shut-off). But now, routinely the digital information display in the...

Anyone running BMR's K-member with lowered motor mounts and ARH LTs. It looks like the passenger rear A-arm bolt and one of the primaries may be within a half inch. I'd hate to dimple those beautiful headers... The lower mounts would benefit me in two ways; first the cat is so close to the...

I did a search for oil leak and didn’t find much so I suspect my problem isn’t normal. My engine has recently developed a leak. I’d like to say an oil leak (I don't really like to say it) but the viscosity just doesn’t seem right and it has a sweet taste to it (not that I’m into tasting...

Mike, I just wanted to drop a public note to say you did a fantastic job tuning my car. The new program solved my cold throttle tip-in perfectly. Thanks for the great attention to detail and excellent results. Now I'm saving money for a forged setup...

I have 18K miles on my motor and I had oil leaking onto my headers today (driver side rear of motor). How good are the OEM valve cover gaskets? Anyone had issues with them failing? I've never removed them or otherwise disturbed them but I'm concerned they may be the culprit.