Check charging system and no EPASS response

[race4food]

So last night I got a Check Charging System/Battery light and there is no input from the Electric Steering.
So to say its light fighting a dump truck turning is mild!

Checked the voltage and its 13.8. Does Oreilleys on car check for Amperage output and is there a minimum for the EPASS to function?

I checked with Forescan and there are no codes.

 

[Juice]

Sounds like a blown fuse at the battery. One or both.

 

[race4food]

The fuse was blown but the break was so small couldn't see it.
So final issue with the swap is still not getting oil pressure gauge to read, I'm using a gen1 sensor with the gen1 harness.

 

[JEWC_Motorsports]

If the gauge isnt reading it should go into limp mode. Im assuming it doesn't run?

 

[race4food]

She runs great. just no reading on the gauges. Gen1 sending unit, connected to the harness. I thought the signal went through the can bus.
Juice how are you running yours?

 

[Juice]

I installed a standalone oil pressure guage.

 

[race4food]

So the gauge does not get signal through canbus? Any ideas on how I might get it running through the cluster?

 

[Juice]

No idea. I dont have a 6 guage cluster. Something tells me oil pressure does not go tbrough pcm.
Based on SCT software, oil press/temp hardware is disabled by default. Aka, it does not have it.

 

[86GT351]

Remember any of the modules in the vehicle rely on battery voltage.