Rear Signal Lamp

[Boy]

My rear blinker bulb went out and i was trying to change it out.
I pushed the plastic cover and carpet aside in the trunk to squeeze my arm in.
I removed 2 nuts and tried to push the taillight out.
It only moved a little.

Am i doing something wrong?
Is there another screw somewhere?

 

[Beerhunter]

My rear blinker bulb went out and i was trying to change it out.
I pushed the plastic cover and carpet aside in the trunk to squeeze my arm in.
I removed 2 nuts and tried to push the taillight out.
It only moved a little.

Am i doing something wrong?
Is there another screw somewhere?

Yes, there are three nuts to remove.

 

[JeremyH]

Lol yes theres is a third nut, its easier to remove the center plastic trim and the side trim to get at it and see it. Its gonna be outboard and down from the other 2.

 

[Boy]

Ok thanks, im luckly i didnt keep pushing cause i was planning to.

 

[Drewskie]

be careful when you remove the plastic trim in the middle... i broke almost all my little tabs trying to get it out