Update: with the help of Jon Lund Jr, we figured it out. My WOT box is missing there for not hooked up. Meaning not bypassed . Lol disconnect all the wiring for it from the harness and fuse box. And fired right up ! Thanks to all of you for the help, I can’t believe I never thought of it until...
Correct me if I am wrong, but I had narrowed to the wire Brn/Grn being for a select shift but for 6r80. Has anyone with a mt82 11’ had this wire in the connector coming off the fuse box for the transmission/power steering harness?
Thats what I’ve been told. I know I did the timing right too. I went over it a hundred times before dropping the motor in. Only thing I can think of is going back and redo timing just incase.
But I have confirmed I do get constant power to ignition coils when key is turned on. Buts looks to be grounding out somewhere or its the PATS code cause at initial key on it’ll be .19-.23 V but falls to .11-.12 V after few seconds . Then I conducted a test turning it over and it goes from .23V...
I have narrowed it down to the wire missing is the OSS sensor. All the other wires in the 14’ harness and the one coming from my fuse box connector line up perfectly. Now my question is would this throw that PATS code, like is it a CAN wire or whatever it is.
Circled in Red is the wire I’m missing off the 14’ harness, and coming out of my fuse box that connector has that what appears to be white/green cable.
I will look into tonight see if pins are lining up, I will also check those fuses for ignition.