While we are on the subject of transmissions and clutch replacements, any advice on an easier way to drop and raise the tranny? Ford shop manual to pull it away until the input shaft just barely clear the clutch fingers and will come straight down. What are they smoking? I'm having issues...
I found that I did pinch the harness. I removed the tranny and that's when I discovered it. The 4 wires to the driver's side primary O2 sensor was totally chewed! Repaired!
So I replaced my clutch again...went stock. I checked my clutch lines, but even after I've done what I can, the car won't go into gear while motor running. I can shift through all gears easily with engine off. Ive bled, and bled the lines, but somehow I keep pulling air out. Any ideas where the...
Thanks, I'm just trying to get the most out of my 4.6. I'm not looking to track it anytime soon. I just want to be competitive against whoever challenges me at a light.
I'm preparing my drivetrain for supercharger add on. I was looking into the edelbrock e-force. I'm looking for 500-650 hp on my 3V 4.6. I believe that is a little over the OEM limit, yes? If not, I would prefer OEM.
Sounds like you got a good base. If you plan on doing serious shows, why not throw in a crate engine? At least you'd know where your engine is at at that time. You can throw your extras on it and would probably be ahead on your hp.
Any thoughts on this? Looking to swap out factory 3.55's to either one of those. Pros/cons for either appreciated. My 08 gt is a weekend warrior and looking to leave peeps in the dust when challenged at the light. But I also like going on long drives with my S192. Is the mileage negligible...