Recent content by hlansford

  1. H

    Roush mustang signature complete seats**SOLD**

    I'm interested are they still available?
  2. H

    Steeda billet charge motion control plates

    So you'd say they were worth it?
  3. H

    Steeda billet charge motion control plates

    I'm considering buying these but wondering if they are worth it. My current set up is 4.10s,jlt CAI, shorty headers, bbk throttle body, 93 tune. With these bolt ons in place already will I see a difference?
  4. H

    Sparkplug Issue

    I finally found the problem that's been causing the ticking on my 06 gt. The thread where the spark plug screws in is either cross threaded or stripped. What do I need to do to fix this? I've been looking for a thread chaser to try an re align the threads but can't find any that will fit the...
  5. H

    Can't find solution!

    I checked the voltage before and it was 1.19 on the stock Tb then I installed the new once and dialed the set screw to 1.19. Should I check it again and make sure it's reading 1.19? Or should I try to adjust a little one way or the other and see if the problem goes away?
  6. H

    Can't find solution!

    I did get a new tune and the problems stayed.
  7. H

    Can't find solution!

    So you'd say only solution is to change tb?
  8. H

    Can't find solution!

    I added a bbk throttle body to my 2006 gt and ever since the rpms are super slow to return to idle after revving. It sounds super draggy and I can't figure out what's causing it. I took the Tb back off and made sure the spring was wound properly and it was so I'm not sure what's causing this...
  9. H

    Are they worth it?

    How'd you like the control plates?
  10. H

    Are they worth it?

    So you'd say get the pulley but not the plate? I'm not ever going to run forced induction be its my daily driver.
  11. H

    Are they worth it?

    I've been considering buying steeda charge motion control plates and sr performance under drive pulleys. I already have 4.10 gears, bbk shorty tuned headers, Jlt series 3 cai, bbk throttle body, full exhaust, and a tune. With all that in mind do you think the control plate and pulleys are worth...
  12. H

    A few pics of my Roush

    That does give me a good idea. Looks great, where did you get that deck lid panel?
  13. H

    A few pics of my Roush

    I'm thinking of buying the gen 5 tail lights from raxiom. Has anyone seen how they look on a Roush?
  14. H

    Having trouble identifying problem?

    Automatic with 4.10 gears. Does return to normal acceleration after that range. Tranny is not sloppy at all and I'm running stock converter
  15. H

    Having trouble identifying problem?

    My 06 gt is running great minus one thing. At full throttle the car runs perfectly til I get to about 70mph at this point it starts to almost hover around 3500-4000 rpm and super slowly gain rpm and there is an extreme loss in acceleration from 70-80 range. The check engine light has flashed a...
See more

Latest posts

Support us!

Support Us - Become A Supporting Member Today!

Click Here For Details

Back
Top