Yes all interior lights will work they run off the sub junction box on passenger floor and off relays in the engine bay. You just gotta make sure you use the original ingnistion switch pigatil and splice your run and request to it. Reverse lights can be made to work just gotta do sone relat n...
I did not repin my connector. I used the fords control pack i removed the previous harness just left the stock fuse box so i could keep headlights and ac clutch relay and a few others.
Yeah i have a 3v ive had since 21 and this 2nd car i found on a farm so i decided to flip and sell but the motor was seized. So basically trusting a used motor was like 2 to 4 thousand. Well f that lets go extreme and swap a gen 2 coyote and completed it. So yeah i talked to power by the hour...
Yeah im not doing all that i solved it by a gps speedometer right now. Power by the hour is working on a gen2 swap wire harness to feed straight into 05 to 09 s197 fuse box and oem harness. Hopefully they work with dakota digital to be able to make a swap cluster and just feed the speed sensor...
I did the gen 2 swap complete and running just dont have speedometer.
Full function 05 original ac compressor and using all the preassure switches, manual clinate control switches and cooling fan
Well as long as you have a speed sensor if im not mistaken you can just wire the lock out box they make to the speed sensor and it activates reverse lock out at 5mhp and up
Tgen you should be all fine. The abs runs off of the sbj (smart junsction box) as well the brake lights go through the stock body harness. The only tricky part is if you need to have reverse lights fucntioning again which was activated by the pcm and just have to wire up through a secondary...
Question 1
Abs is its own stand alone system that run off the smart junction box in the cab. And i think still pulls its tower from the electrical fuse box from the engine and does speak through to the cluster through the high speed can bus. The pcm only does traction control through the abs...
Yes tried sgi 5e and called them to trouble shoot. The issue is that you need to be pin the oss into the pcm connector for it to read, then you need to go and access the pcm through program and have the pcm be able to recognize the sensor so it can calibrate and send the inputed info into the...