The PIC WHORE CLUB!!! Knock before you Enter!!!

Anti

forum member
Joined
Jul 24, 2017
Posts
612
Reaction score
275
Location
HSV, Alabama
7X9Y6un.jpg


You been holding out on us!

I guess it is in the grass pictures time. Lol

20201020_173104.jpg

20201020_173112.jpg

20201020_173122.jpg
 

06 T-RED S/C GT

forum member
Joined
Jan 8, 2016
Posts
2,270
Reaction score
369
Location
Carnegie, PA
Your GT500 blends in very well with the contrast and shape formation of the clouds. Also really like the imagery details of the horizon, as you can visually see from the images that it goes on for infinity. Needless to say, you did an awesome job with the photos and also picked the ideal scenery location as well. Meanwhile, thanks for sharing :waytogo:
 
Last edited:

Rich

Member
Joined
Dec 26, 2020
Posts
231
Reaction score
175
How long did it take you to get it done? With your car half in/half out of the garage I assume it was less than a day.
 

Anti

forum member
Joined
Jul 24, 2017
Posts
612
Reaction score
275
Location
HSV, Alabama
How long did it take you to get it done? With your car half in/half out of the garage I assume it was less than a day.

I had so many interruptions I couldn't tell you. Plus it was my first time and I stressed over the gear tooth pattern pretty badly. Plus I had to stop a few times to go get some or rent some tools I didn't have.

If I had to do it again, I could get it all done in a long day, pretty sure. See, I swapped my diff for a eaton trutrac and replaced every single bearing including my axle seals and bearings with koyos. I had a pretty bad amount of metal shavings in the tubes and pumpkin too. So I cleaned it very thoroughly. Laying on the ground and it being 29 degrees didn't help my pace either. So to lose my frustration and to not throw tools I repeatedly told myself I was in no rush.

Oh, and since I had the drive shaft down and mid mufflers out, I put in my mgw shifter that has been sitting around for a year plus.. lol


Just jerk the whole diff out and work on it on the bench.
By the way Anti; That is one nasty looking bearing.

View attachment 75735

Yea, it was ugly for sure.. lol. Someone had been in there previously too. It had three brands of bearings in just the diff housing..

I wish I could have pulled the whole axle out, but I had too much in my garage at that time.. :(
 

Latest posts

Support us!

Support Us - Become A Supporting Member Today!

Click Here For Details

Sponsor Links

Banner image
Back
Top