Separate names with a comma.
The factory studs are to long and will contact the tubes in some locations.
You can take one of your original bolts to home depo or Lowe’s and compare the threads to the samples they have in the fastener section. Then you...
Your choice of headers and gaskets will determine which bolt set would be the best match. How thick are the flanges and how thick or crushable are...
Sounds like what would happen if the stability control took over. Cut the throttle and apply breaking too stop you from sliding.
Alternator charging the battery with good voltage but the battery goes dead overnight. Classic diode failure symptom.
Fuel pressure and temperature are available in your SCT datalog along with the fuel pump performance.
I have noticed when I push the line lock button the break lights come on even though I’m not stepping on the break.
The diode is added to the wire between the break switch and the PLC. It prevents line lock power from back feeding into the PLC. The diode was...
Without the diode, when I turned the advancetrack off and set the front breaks with the line lock I could do a burnout but when I let go of the...
No cats, cherry bombs and no Flowmaster. Then run cams that open the exhaust valves about 65* BBDC. Should pretty much make the glass rattle.:driver:
On my 2010 I had to install a diode in the break pedal wiring to prevent the advance track from interfering with a burnout and hard launch. On...
Yes, I have replaced that seal on several different engines. I prefer to have the cover off when changing that seal.
Looks like the damper seal in the front cover to me.
Congratulations. I love being retired.
It could have been a signal for a shift light.
Went for a short test drive this afternoon. Got caught in a hail storm two miles from home. NT05 315s on the back really suck on slush. Made it...
Project complete. Setting on all four and waiting for a tune update so I do a test drive.
Great day working on the car. After finding the twisted yoke I pulled the rear end to look for damage.It had a loud whine. Yep, pinion bearings...
Don’t know if you need one or not but using a cover/girdle like this one can reduce the deflection of the carrier bearings. [ATTACH]
Pretty darn close. These are Thrush 24” overall length.
Through an old school 3” glass pack side exit exhaust system together. It’s loud inside the garage. [ATTACH]
That bearing is damaged and will fail. At the most inopportune time. That little idler is spinning 3 times faster than the engine.
Yep, it would suck to break it without a backup. Hopefully you can slap a new one on there and repair that one for a spare.
Can you replace the bearing?
Dish washing liquid and hot water with a bottle brush will work fine for cleaning the oily goop out of the manifold and I am real curious where...
