Search results for query: *

  • Users: Ryan D
  • Content: Threads
  • Order by date
  1. Ryan D

    Rad support crossmember

    If I cut out the crossmember (leaving the outer 6 inches on each side for the rad mounts), are the front frame rails along with the bumper support across the front strong enough to hold the unibody/rails in place? Sure would make my lower rad hose routing work out better if I could do that.
  2. Ryan D

    Connector diagrams in the BEC / ECU?

    Through search have located plenty of diagrams, but they all seem helter skelter for what I'm looking for. Most importantly, looking for a diagram of what comes from the BEC connector that goes to the front of the car. There's not a whole lot on that one, and have managed to trace some of it...
  3. Ryan D

    Connecting different style compressor to factory A/C lines

    Really would like to make my A/C work out on this drag week project. Sanden SD7B10 Mini compressor was my only option to fit my setup on this LS swap into an '08 GT. Have the fitting coming today to adapt the compressor flange to o-ring style fittings. Problem is, I need to either go 90*...
  4. Ryan D

    What are the options for retaining a/c and power windows without Ford ECU

    If you moved to an aftermarket ECU, could you keep your a/c controls and power windows? Is it possible to leave the factory ECU and just disconnect all engine wiring connections to it? Would run a Holley EFI system and Holley dash, so not concerned with gauges or anything of that nature. Just...
  5. Ryan D

    Selling car with a tune in it

    I know this has been discussed on here but haven't found exactly what I'm looking for. Going to sell my '08. It's got cold air, gears and hot rod cams in it, so it's been "tuned" for those. Supposedly requires 93 and that's all I've run in it since I put the cams in. Current tune has the...
  6. Ryan D

    Pacesetter off-road x-pipe fitment update

    A couple folks asked for an update on fitment when I got around to putting on my pacesetter off road X from Summit. Got in on this afternoon, fitment was perfect. Removing the factory catted H, not so fun, but the new pipe fits perfect. I will warn you, the bung on for the passenger side...
  7. Ryan D

    Steering column conversion electrical questions

    Have searched but haven't found exactly what I'm looking for. Working on build/to-do list for building a drag n drive car for drag week type events and occasional cruising now and then. Will go with 8.50 cert cage but keeping interior except for rear seat delete. Want to go to a race column...
  8. Ryan D

    Short-term wideband install question

    Have an AEM wideband I need to install for now, will be replacing everything when the engine comes out in spring but for now just want to use a clamp on bung. Which clamp diameter is needed for stock manifold/mid pipe? I haven’t seen anything definitive but did run across someone saying that...
  9. Ryan D

    Different power level tunes for supercharger?

    Hello all, been lurking awhile and finally signed up a week or so ago. Have done some searching and can't find what I'm looking for. Have an '08 with frpp intake, cai, hot rod cams, gears, and barton short throw. Looking to put a forged shortblock in it and supercharge it, use my heads but...

Latest posts

Support us!

Support Us - Become A Supporting Member Today!

Click Here For Details

Sponsor Links

Banner image
Back
Top