Search results for query: *

  • Users: 07 Boss
  • Content: Threads
  • Order by date
  1. 07 Boss

    Finally got wheels and tires.

    Had an issue a while back and busted up a rim. Took a while to search and find somethin comparable to the fronts with the right offset and then had to find tires that fit. I ended up going on size smaller than I had because the only tires available in that size were drag radials. I put...
  2. 07 Boss

    Luckily had one in my Trunk!

    Was taking one of the final turns on my way home for a couple hour break from work. Took it rather enthusiastically as I kind of drive her like she's stolen. As I was just past the apex, heard a clunk as the suspension went over a bump and then the body shifted sideways like i was going to...
  3. 07 Boss

    Road Trip

    Rented this for my drive this week. Not real fond of the dropped nose but she’ll do.
  4. 07 Boss

    Where exactly is the door sensor located?

    I think I have had my door panel off once in the 15 or so years I've owned this car and for the life of me can not remember seeing where it was located or if I saw it at all.
  5. 07 Boss

    C clip removal from Auburn Pro Series

    Like it says, trying to remove the c clip from the drivers side axle. I have an Auburn Pro diff. I removed the pinion shaft but can’t push the axle far enough to get the c clip off. Is there any tricks to get the axle in farther. I only need a fraction of an inch.
  6. 07 Boss

    Axle Reluctor Wheel and Wheel Studs

    I'm getting ready to swap out my axles or maybe just the one that is bent. Either way can I reuse the reluctor wheel? Can I just whack it off of there and use it again or should I get new ones. And I've never done it before but can I bang out the wheel studs and press them into the new axle...
  7. 07 Boss

    Done Looking for DR's

    Looks like I'm gonna have to run a regular street tire since DR's don't seem to be available in the size I need. So I will step down a tire size and go with either a Nitto trip 5 G2 or NT05, or the Michelin Pilot 4S. Those seem to be the tires available in a 295/45/18. I haven't run a regular...
  8. 07 Boss

    Looking for a couple of these

    To make a long story short I need a couple of wheels in 18"x10" with a +45-+50 offset. I've looked for a little while but can't seem to find them in the right size and offset. I thought it would take about two minutes but I keep hitting walls. Was trying to avoid AM because of quality issues.
  9. 07 Boss

    Car rental

    Picked up a little 5.0 for the road trip. Trying to figure out driving modes on the fly. I guess just put it in sport mode and turn off the traction control. Sorry for the bad lighting. Afternoon sun. Don’t know what this silver is called but I like it.
  10. 07 Boss

    Bolt Specs...

    just off hand does anyone know the bolt sizes for the belt tensioner? Ford want like $20 something. Went to lowes to match it up and couldn't find a match. Also does anyone know the size bolt for the idler pulleys? I have an aftermarket set but I have to throw a stock replacement on there...
  11. 07 Boss

    Anyone recognize this connector?

    So I had to unwrap part of my harness around the front of the engine to replace the power wire to my water pump. Anyways I found this connector with both ends cut. Now mind you many years ago I did a semi wire tuck. I did it in sections and never had the entire harness unwrapped...
  12. 07 Boss

    WOW $1000 for two tires!

    I drove a couple miles on a half deflated tire. Effed up the sidewall so I had to get as new tire. Well it's saturday afternoon at like 4 pm and I can't find the right size tire near me that I can get my hands on and need the car running since my other two are down. Anyways decided on a...
  13. 07 Boss

    #2 Cylinder Eating Spark Plugs

    Well not really eating them up but destroying them none the less. Not sure what is going on but this is the third plug I have had to replace prematurely. It's always been on the #2 cylinder. I generally pull my plugs once or twice a year just to look and clean them and swap them out before...
  14. 07 Boss

    If my Timing Chain slipped?

    If my timing chain slipped a tooth or two wouldn’t it throw a code?
  15. 07 Boss

    Is this a real Muffler Bearing?

    I’ve seen blinker fluid and a flux capacitor but this is my first muffler bearing. Just wanted confirmation.
  16. 07 Boss

    Picked up a new Tensioner

    Had a Thump Racing belt tensioner on there for quite a few miles. Started making noise no matter what pulley I put on there so I think it was internal with the spring/swing mechanism. Anyways I just threw a stocker on there for a while and actually went through two as the pulleys are now...
  17. 07 Boss

    New Whip for the Week!

    I was supposed to rent the 720 hp Hendricks Motorsports ZL1 but it’s not available so I had to get a regular GT but I’m not complaining. I guess I want to put it in Sport mode. I’m assuming the turns off traction control and not abs. Someone correct me if I’m wrong because I don’t feel like...
  18. 07 Boss

    Blend door question

    So apparently my AC is working properly but the air coming into the car is warm. Which actuator controls the air between the ac and heat? Can I just move the arm manually to the cold side for a quick fix until I get a chance to replace the actuator?
  19. 07 Boss

    SHR Flush Mount Louvers are back

    Just an FYI because a couple a years ago when I was getting my car repaired we were unable to source these and I went with some different window cover scoops. Never liked them as much as the louvers. Well fast forward to today as I was looking for some idler pulleys I started browsing and...
  20. 07 Boss

    Back into a Little Turbo Vert

    My 07 GT has been my daily then race car then back to daily. Needless to say she is not the most ideal little commuter car with the current set up. So I went out and got me a little turbo roadster. She is old but had less than 50K on the odometer and less than $10K. Found it up in Oregon and...
  21. 07 Boss

    So I think I’m gonna sell my car

    It’s been a good run but I think I’m gonna try and sell her off. I’m gonna loose a grip on the ROI as I probably have dumped $25K into her. Just time I think. I’m building a race car in the garage and am about to pick up a little 2 seat turbo vert to putt around in. I can probably get by without...
  22. 07 Boss

    Leave it or Paint it...

    So my door panels finally started to peel. I'm surprised they have gone this long in the heat of the desert. Anyways I got these abs panels instead of gluing pleather on there. I was wondering if I should leave them grey or paint them Satin Silver with a clear coat. And if I paint them...
  23. 07 Boss

    Looking for an SN95

    I know it's not really the right forum and definitely not the right sub-forum but I figured that many of you here might have some insight. I got a friend looking for a first time car for her son, he wants a mustang. Looking at SN95's cause the budget is under $5K. Doesn't need to be a GT or...
  24. 07 Boss

    It's Happened Twice Now....

    A week or so back my car overheated as I pulled into my driveway. Water pump is pumping, fan is going. Weird shit. I cooled her back down and added water to the system and then could not duplicate it. Idled in the driveway for 30 min. with ac on. Turned ac off and ran a high idle for about...
  25. 07 Boss

    25 Greatest Mustangs

    Just sharing an article I read this morning on some iconic and some not so iconic mustangs. But a fun read. https://www.hagerty.com/media/automotive-history/25-greatest-mustangs/?utm_source=SFMC&utm_medium=email&utm_content=20_June_27_Newsletter_Weekend

Support us!

Support Us - Become A Supporting Member Today!

Click Here For Details

Sponsor Links

Banner image
Back
Top