Search results for query: *

I spoke to Brenspeed and they said, O2 sensors don't heat up quick enough at relocated collector position they may spit out a code. This was happening to me and occurred in the spring and fall when outside temps were lower than summer. They sent me a new tune to handle this.

feel better now? quibble numbers, it's a 475 horse pkg pulling more than it should, and approaching an area the retailer wasn't comfortable with is all I'm saying.

I sent mine back to Tremec in a large rubbermaid tote. It's under 150Lbs (just the transmission) so UPS it for a little over $100 depending on how much you insure it for.

No it was a chassis dyno, 512rwhp 467 rwtq. Brent speculated it was 600+ at the crank.

Brenspeed rev limited my stock bottom end 3V to 6200rpm to save my engine when it dynoed just past 600hp at the crank. Which kept the torque at a flat 465 from 2000-6000rpm. I have almost 50,000 miles on it.

I had purchased my RXT in Oct 2016 and had the same issues as you. I measured the center disk against the floater straps and they were about .028" apart. I thought that was too close and sent it in for warranty repair after talking to Mcleod tech. They completely rebuilt it with a new for...

Good Morning and welcome!

IDK 'bout that, my stock axles bent .064" by doing dry burnout. Up on carlift in gear, pretty bad tire wobble and bearing whine.

Thanks racer, that's just what I did. I'm in Appleton, you?

Thank you Sir. In any event I'll zip tie the two together until I cant figure out how to defeat using both.

is it possible for me to link the two separate harnesses to a single switch?

My 2010 GT man trans has two brake switches on the brake pedal assembly. Why would there be two? I've installed a 2011 Shelby Ford Brake pedal assembly and there is only one place for a brake switch, everything else being the same (except beefier). online ford parts diagrams are inconclusive...

I had my CAI intake elbow Blow off from the throttle body because of the high pressure air dryer at a car wash. caused a freaky idle with my saleen S/C

Installed Xbrace rear seat delete kit

Installed the new T56 Magnum tranny kit from D&D, now i have to replace my bent axles.