ECM / PCM

[2Goody]

I bought a 06 GT - would not start
Codes were
B2103
P0600
P2105

I tried to get my ECM reflashed, the company that I sent it to, module experts, Said it was not reflash/repairable.

I ordered one of eBay. The code ends in YB like mine does. Once it arrives, could you tell me what I need to do? Can I program it myself?

I also bought a ECM from an 06 V6 but I don't dare to install it out of fear that it will mess something up

Thank you for the help!

 

[Macman45]

Need to have PATS programmed on the eBay ECU

 

[Juice]

Which code said to replace PCM? I'm not looking them up..

 

[rocknrod]

B2103 Internal Transceiver PCM REFER to Section Antenna Damaged
P0600 - Serial Communication Link Description: Indicates an error occurred in the powertrain control module (PCM). This DTC may be set alone or in combination with P2105. Possible Damaged PCM - Go to Pinpoint Test QE.
P2105 - Throttle Actuator Control (TAC) System - Forced Engine Shutdown Description: The TAC system is in the failure mode effects management (FMEM) mode of forced engine shutdown. Diagnostic Aids: This DTC is an informational DTC and may be set in combination with a number of other DTCs which are causing the FMEM. Diagnose other DTCs first.
I couldn't find Test QE in my service manual, just suggestions to go there.

 

[Juice]

Ok,
Cannot use the v6 pcm in a gt.

The bare minimum you need to do is PATS to make the replacement pcm run.
VIN needs to be programmed.
May need axle ratio/tire size programmed if speedo is off.
You need IDS or Forscan and Vlinker USB adapter.