AHaze's latest activity
-
AHaze replied to the thread Ford 460 motor swap.There's a few 385 series BBF swapped S197s out there. The one I know the most about retained basically none of the original electrical... -
AHaze replied to the thread SUPER SNAKE!.I wasn't saying any of those cars are direct competition for this Shelby, just something else someone with $200k burning a hole in their...
-
AHaze replied to the thread SUPER SNAKE!.Figuring these will start in the $150k range (2023s started at $140k+), I went "shopping" with $200k I don't have. I assumed there would...
-
AHaze replied to the thread The PIC WHORE CLUB!!! Knock before you Enter!!!.Someone had this seriously slammed antique fire truck just parked at the local rec center. Owner was nowhere to be found.
-
-
AHaze replied to the thread 19" wheel width.IIRC the only 19x9s were the Brembo package wheels and the fronts on Boss 302s (which got 19x10 rears). GT500s got 9.5 wides all around...
-
AHaze replied to the thread Magnum 500 Wheels.The GT came with bigger front brakes than the V6. The OEM 16" base wheels will not clear the GT brakes. Can't say with 100% certainty...
-
AHaze replied to the thread 05-09 GT power steering reservoir relocating help.Download the install instructions for a Vortech/Paxton supercharger. The reservoir gets relocated to the passenger side with simple...
-
AHaze replied to the thread Fuel pump issue.I just replaced it with submersible rubber fuel line. Carved some barbs into the plastic bits the hose connects to and used stepless...
-
AHaze replied to the thread Fuel pump issue.Had the same issue last year. Crossover tube had a leak in it so once the fuel level got below the tube, it just sucked air. I couldn't...
-
AHaze replied to the thread 07 to 14 Coyote swap.HIDs were available on the later pre facelift S197s ('09 for sure and I think '08 as well) the housings are pricey but installing those...
-
So it's raining outside or wet and I dont play that so here it is inside my little shop. Lowered it exactly 1/4" lower than the rear...
-
AHaze replied to the thread Gas Gauge Curfufflal.There's a sending unit on both sides.
-
AHaze replied to the thread Rear Springs 1" Lower.Huh? The top coil is flattened (nearly perpendicular to the axis of the windings) and is almost 1-1/2" smaller in diameter than the 2nd...
-
AHaze replied to the thread Rear Springs 1" Lower.Front springs on these cars are tapered and flattened at the top (the end being held up by the jack stand in the photo) but can be cut...
-
-
AHaze replied to the thread Rear Springs 1" Lower.I'll go against the grain and say cutting coil springs FOR THE PURPOSE OF MAKING SMALL ADJUSTMENTS to the front ride height is fine...
Latest posts
-
-
-
-
Drag racing experience - 15 or 17 inch rear wheels?
- Latest: Red-Candy-Metallic
Support us!
Support Us - Become A Supporting Member Today!
Click Here For Details
Sponsor Links
