Recent content by Brezick

The Kenne Bell design for the 3v is a terrible one, so you cant compare it to a centri setup. With 4.10's, it was a bit rough. But the overall heat problems of the KB made it entirely not worth the build. That 16lb with all the timing pulled felt like a pig after a run or two.

standard motor, bit lower on compression, 16lb boost, pumping straight meth into the intercooler, biggest heat exchange i can find and custom 3 gallon tank filled with ice. Some have been able to get more by having a custom elbow made on the rear since the inlet is just too small. Sold the car...

it doesnt matter how strong or how much boost. That KB just will be too hot, ice wont even help. best i even got without pulling my hair out over heat was around 550.

That was my thought. I have no issue disconnecting and reconnecting an end link every track day.

Welcome. Born and raised in the burgh, just over by the waterfront. If you want, check out Pittsburgh Car Scene on facebook. We usually meet every Thursday down by Dave & Busters. Alot of mixed breeds usually.

The only part I don't have is a roll bar. I assume I will need one, but since you released that new bolt on bar I am not sure which would be better. Car is ~4100 lb convertible, Hellion TT, 6R80. Should break just over 1000, but still finishing up the motor. I have BMR's K member, A arms up...

This is what is done to mine rather than just screwing in supports. The water jackets are filled and welded. Coolant still flows through the drilled holes and they match what the head gasket in terms of coolant passage. will handle the 1100 I should hit no problem.

Very nice...just need the ARB and my vert will have the same complete BMR catalog. :)

JPC/CPR single both have show to perform extremely well. I bought the Hellion TT kit about 2 years ago. Install was pretty easy - we did it on jack stands and swapped the k-member at the same time. It does come with its own headers, but as you mentioned, they are basically just reversed, with...

In the middle of this right now. Doing all own work, turbos, motor, suspension, and 30k in. still need fuel, rear end, and saftey gear. another 10k+ easy there.

I dont like the 5k price tag. I guess if you are building from scratch. While sleeving is also 2k+, i went this route and got a block that had the jackets filled. should hold 1k just fine.

Car is a base A6. 1 - I do get the key chime when the doer is open and key is in. When I turn the key on, most of the dash lights turn on, and I get the messages Service Advancetrack, Check Charging System, and Mileage -------. 2 - I know when it will start, as when I cycle the key on, the...

Terminals are clean as can be, never had much corrosion. Battery has been load tested. Tool is pretty old, but still worked. Also as I mentioned, all other electronics and power accessories are running at full just on battery, so its got good juice.

Just went out and checked, both keys have the same result.

My 2013 GT A6 is having issues starting every morning. It wont even turn over, but after a few key on key offs, it starts. I am thinking its a short or lose wire somewhere, but I dont know where I should look. What happens is I get all the dash lights and ------ miles, so I know the dash is...