Recent content by dventers

I have 05 GT 4.6 with less then 5k on it ford hotrod cams. Ford hi flow intake L/T headers H pipe and still has converters Brenspeed 93 octane tune throwing P2198 code. new ford EV6 injectors. Put new o2 sensors in (all 4 of them) checked for intake leaks and exhaust leaks...can anyone give me...

Jus replaced pump and filter with same results..could the fuel pump driver module cause this issue.??

So after putting a remanded engine in and noticing they used dorman phasors I replaced timing set with ford parts..finally got that all done..my issue now is the engine wont idle and gives code for low fuel rail pressure.. i've replaced o2 sensors,mass air,fuel pressure sensor even tried...

Checked to be sure it is seated properly and both sensors are identical I...built many of these and never seen anything like this happen...

My apologies.. they are ford hot rod racing cams...I thought the same about one being longer and did confirm that they are on right side..

Hey guys, first time poster and I'm at a loss here hoping someone can help.. so to start, the engine is a reman with FHRR cams, FHRR intake and tb, it had dorman phasors out of the create, I didn't want to trust that so I got the ford racing timing set, instal went rather smooth when I cranked...