I had some Caltrends in my 00 GT convertible some years ago. They fit pretty well with adjustable straps to tighten em down, but I didn’t like using covers really except for the fact that it was a convertible and the neoprene didn’t get scorching hot in the sun. If it’s a coupe and you’re...
Thanks again for the advice earlier.
Just an update. JPC recommends the BMR GT500 loop. I’m checking with Kelly on a loop that will accommodate a 4” driveshaft. I think the 326 with a TR6060 should be a similar config to an 07-09 GT500.
Again personal experience would be helpful. I could...
I’ll take a look at CHE.
Kelly at BMR wasn’t sure if their loop would fit a 4” driveshaft coupled with a TR6060 and a 326 stroker.
I’m checking with a couple of other sources. Thanks
Anyone running a 4” driveshaft with a safety loop on? I’m looking to do the TR6060 swap and use a GForce 4” driveshaft. I also have Kooks headers and the motor is lowered about 1/2” if that affects any clearance requirements.
Any recommendations? Thanks in advance.
I’m running a staggered setup. I’ve got 305/45/18’s NT555R’s on 18x10’s in the rear and 255/45/17’s NT555 G2’s up front on 17x8’s. I’m also using FRPP “Foose Stallion” springs which drop the front and rear about 3/4”. The cast iron Boss 5.0 block probably drops the nose another 1/2”. LOL
I...
I would agree to Gabe's point that the sidewall bulge with 305's on a 20x10 would be more severe than 305's on an 18x10 since the taller sidewall is more forgiving.
I think the fit on your rims (Jason) looks good! Sidewall bulge should be kept to a minimum on 20" rims for sure though.
I'm...
Anyone have an extra Vortech/Paxton 2.95”, 3.00” or 2.87” 6-rib pulley that will fit a Novi 2200? I currently have a 3.12” 6-rib pulley but looking to step down just a little bit. I don’t feel like dropping $100 to experiment with pulley sizes though.
Thanks
Yeah, I found the source of the whining noise. It occurred to me that it was like a kazoo, getting air to move through a hole at the right frequency to create a harmonic vibration. Turns out it was from a temporary cap I was trying to use when I removed a BOV. Earlier this year, I swapped...
So, I was at a local Ford dealer and there was a 2014 RS3 sitting in the showroom. I noticed the insulation hanging at the firewall. I was thinking it might be a good idea to add to my 2005. I tried googling it but anyone have a part number handy? Wondering if it's 05-14 or just 10-14. FYI...