Currently used for SCCA Rallycross. First built for Drifting. Can be altered for your type of racing.
My next steps was to but 17in all terrain tires on it, do the rwd Scca Rallycross championship, redo the cage, then do stage rally with it
General info.
Salvage Arizona Title. Back left...
Haha hey guys still got the car and everything. It’s just been garaged after the event I ran it in. I’m actually going to be selling it now with losing my job and blah blah.
So it’ll be posting it up sometime next week, there’s a pretty bad knock on the rear end from either the suspension or...
Small update. Finally got a chance to get my hands on the car, mostly looked over the rear end. I extended the rear upper arm a bit since I raised the car, pinion should be at a better angle.
One thing I’ve been confused about though, where the I put a angle finder to measure?? On the flat...
Thanks guys for the support, it is tons of fun. And really challenging trying to go fast in dirt. Especially on normal road tires lol. This weekend I’m planning on inspecting everything on the rear end, also checking the drive shaft too. The rear end sounds terrrrrrible now just cruising around...
Hey guys! Big update!
Ran my first shake down event at Vegas Rally (where you can sign up to drive rally cars about an hour out of Las Vegas).
Car ran phenomenal! Other than the rear end sounding like it’s going to destroy itself I had no other issues. Car was fast, and I even jumped it twice...
That seems like a way that it could be done, what do you think of adding some sort of material to the pedal surface to extend it that way? I might not have to make a stop then too
Hellooooo, does anyone know a way to adjust the brake pedal height or throttle pedal? Or maybe even some plates that go over the face of the pedal to help.
My issue is I really like to use my left foot to brake at track days, but with the mustang the brake pedal is a lot higher compared to the...
Whoa I haven’t been on this site in a minute. Got an update though!
Ordered some 16x7 wheels through summit. Everything measured out, the hub bore, bolt pattern, wheel stud size, ect.
But when they came in the lug nut holes were wayyyyy to small! Measured with my calipers and they were actually...