Search results for query: *

I just use the same stuff (tensioners, chains, phasers...) over and over. The only problem I ever had was using the *steel* tensioners from pre-SN197's. Over the course of two years, I ended up having each side rail broken at least once. Made an awful racket, but didn't jump a tooth (or two)...

I had a weird leak that also left no residue, but I could smell. Spent weeks looking for the source and couldn't find it. It was suggested to me that I pick up a sniffer. Found out the technical name is a "combustible gas leak detector" on Amazon and grabbed one for $37 (UEI). Working...

Bad connection is a lack of continuity, which prevents the clean flow of signals. It can be cause by corrosion, bad pin, bent pin, recessed pin, or bad wire connecting to the pin(s).

Looking to round up some 05-10 COPs (Coil on Plug). Send me a message. Mike

Looking for a SCT Tuner X3 or newer, and it must be unlocked. Mike

Luckily I had a one of those 2000lb ratchet straps in my emergency supply bag in the trunk. BE PREPARED!! <grin>

Kelly, sent you a PM.

How can I tell?

First off, I want to thank Frank Stoddard @ Steeda for taking care of this issue very quickly. Story begins when I noticed a tilt in the car on the passenger side of about 1-1.5 inches. After starting in the rear and working my way forward, I finally found what I though was the problem. My...

Sent you PM with a question.

How much shipped to 78633?

How much shipped to 78633? Which model number?

Please send me a picture to [email protected], as well as your price shipped to 78633. Thanks, Mike

Need a good 8 bolt flywheel that can immediately be used without an extensive cleanup or resurface. Will be shipped to 78633, Georgetown Texas (Austin Area).

I'm using 18" Vibrant resonators right next to each other right before the hump over the rear axle. Eliminated 99% of my drone, and as an added bonus it mellowed out the tone to a throaty sound. Amazon.com: Vibrant 1792 Bottle Style Resonator...

When (or if) you removed the thermostat, did it help? When you did your most recent testing, what was the air temps and humidity?

Lito may be able to tell my logs, or a special configuration file log

Good deal, he does mind too. Get with him, do some datalogs, and get it tweaked.

Who did your tune for the new cams? If you didn't get a tune done that's a problem. If you did, is it custom or canned?

You swapped in hot rod cams from the stock cams?

Just re-read the thread. You wrote that you changed cams. What did you change them from (stock, etc...) and what did you change them to?

Ebay.

Yes you can, however... - The marks you made will work great. Just line up the new and old phaser and put the marks in the same place. - Where did the small rivets go that held the timing ring onto the phaser? Did they drop into your engine? If so, not good. - I don't see a wedge tool...

Well, at 52 years old and 30+ years with the Army, I'm being forced into getting a new clutch for the car described below. Not being forced because of physical problems (well maybe a little), but I'm no longer drag racing the car, its' my daily driver, and I've picked of a nasty intermittent...

The main wiring diagram/schematics: http://iihs.net/fsm/?dir=40 Speed Control: http://iihs.net/fsm/?dir=40&viewfile=Speed Control.pdf Look at the wiring diagram for the Speed Control, and you can see several things other than fuses that could be a problem if that doesn't fix it. Mike