Search results for query: *

I have all the pedals out of a 2007 GT and a brake booster with master cylinder $150.00

I have a 2008 v6 mustang. After the car sits a week or so the battery is dead. The battery is brand new. I unhook the negative terminal and put a multi meter between post and ground cable. is showing 13 volts. Pulled all fuses under hood, relays and also in the car by the passenger kick panel...

Looking for a nice headlight harness from external fuse box to all lights

looking for a hood insulation pad.

Anyone no what is involved in putting a front bumper cover from a gt on a v6 car. do I need a wire harness and switch from a gt. really don't have to have functional fog light but if they are there it would be nice if they worked

need an A/C condenser for a 2008 mustang.

how do I remove the shift cable where it is connected at the trans linkage arm. It looks like it just slides over the a round pin but I don't want to force it

Bought a 2008 mustang that hit a telephone pole and bent the lower front frame rails. Is there a manufacture that makes replacement rails? They are bent in front of the k-member out to the radiator support. Any advice will help

.........................

Has anyone used this wide band and what do you think of it. Looking to buy wide band and would appreciate any advice and recommendations

Looking for a radiator and fan for 4.0 mustang. I believe 4.0 and 4.6 are the same

Need a pair of hood hinges for a 2008 mustang. Let me know what you have

Looking for a grill and bumper cover for a 2008 mustang v6 car

I am looking for a front clip for a 2008 v6 mustang. Let me know what you have

I have a 2007 4.6 blower car that keeps fouling plugs. Thinking of replacing the 02 sensors and wondering if there is any thing else I should consider. I run Brisk plugs that are for blower engine. Any thoughts will be greatly appreciated

2007 4.6 blower motor. clean the plugs up and it runs great. put in the garage overnite and start the next day and it smokes at the start and runs like crap. Thinking its valve seals but the car only has 29000 miles on it. Wondering if it could be something simple that I am not thinking of. Gap...

Is it possible that the cruise control was disabled when my tuner turned off my trac control. Seems it has not worked since it was done . Not sure if they together.

Years ago I had my rear built for the track. The guys that built it went into the computer and turned off the traction control so it cannot be turned on or off at the dash button. Since then I put a Detroit trutrac carrier in the rear. My question is can I turn the dash switch back on and will...

I have a stock 3650 5 speed in my 07 gt. The trans has been rebuilt twice and needs it again. I have tons of money in clutch, driveshaft, shifter etc. I thought about a tremec xl magnum or a tko 600 but I can't use any of the parts I have for the swap. Is there a better trans out there what I...

I am going to be swapping out my stock trans. This is the 3rd trans in the car so stock has to go. Would put the tremec magnum 6 speed in it but I would have to change all the good stuff I already have(drive shaft, shifter ect) If I go with a TKO 600 can I do the swap and not have to change all...

Pulled the front header 02 sensors off to replace and noticed 1 was different. 1 has slots in it and 1 has holes around it. Are they both 02 sensors and 1 just a different brand or is 1 not 02 sensor if so what side does the 1 with holes go on????

Has anyone ever had this? When starting the car it seems like its running on about 6 cylinders, very flat, pops thru to exhaust a little. It will run like that for awhile until warm (195). After hot it runs great. The engine is a blower motor. Wondering if there is a sensor or something that is...

Is there a way to tell if a maf sensor is bad on a blower motor with Mafia? When I unplug it from the sensor it keeps running but when I plug it back in it stalls then starts like it is flooded after a second it clears

I have a water to air innercooler that has a 1" hose that runs from the cai box to a vaccuum valve and then to the underside of the upper heat exchanger just infront of the throttle body. Can anyone tell me what this is and how it works with the innercooler?

Looking to change from Nittos to MT radials. What is the tallest tire can I put on a 07 gt with 18" wheels. I have low profile nittos now (285x35zr-18) Looking to fill the wheel welland get more bite on the pavement. Thanks