5.3 Side Emblem

[Boone]

Has anyone ever tried to make a 5.3 side emblem out of a 5.0 and a 3.7? I'm doing a stroked big bore 323 cu in, and I'd like to advertise it subtly (at least while it isn't running). I'd like to do it in black.

 

[GallopingFord]

Best bet is find someone who can create CNC Billet emblems for you. It's been done.

 

[Boone]

I contacted UPR because they offer both emblems in billet. No response yet, but it's been under 24 hours, so not worried.

Anybody have a source willing to do the 5.3 emblem?

 

[joe_momma]

I've seen a site on the interwebs that does custom lettering, and they use the "mustang" font. I found them a few months ago when I was looking for some custom lettering for my rear. Sorry but I don't have the link any longer.

 

[Ingwe]

Was considering the same thing for my 07 with a new FRPP modular stroker block before it was totaled. I was assuming the 5.0 badge and the 3.7 could be cut and glued to make them work together with a coat of plasti dip. The 15 5.0 badge is a slightly different shape so if you're going to have a crack at it then make sure to use the 11-14 badge.