bmr front safety loop and x pipes FYI

[rojizostang]

just a little fyi...if you buy a bmr front safety loop, it may not bolt up to the tranny mount without some modification if you have an x pipe. i had to make a new set of holes on the main support to raise the loop up high enough to clear the x pipe. no big deal, just a drill a couple extra holes. no pics sorry, didn't feel like hunting the camera down during the middle of all that.

also had to remove the x pipe mounts that go into the hangers under the tranny mount to make it all work

 

[DarkFireGT]

I did not have that problem, but mine hit the shifter.

 

[rojizostang]

I did not have that problem, but mine hit the shifter.

you must have mounted it in the forward set of transmission mounting holes. i had it there, but like you said, it hit the shifter, so i moved it to the rear set. it also moved the loop just behind the slip joint of the drive shaft right before it tapers up to 4 inches rather than placing it right on top of the rubber boot covering the slip joint.

i have a pseudo spydershaft