cobrasrslow60
forum member
- Joined
- Aug 26, 2010
- Posts
- 500
- Reaction score
- 1
Alright guys I just want to go over this once so i make sure i do it correctly...
1. vacuum line from bov to vacuum line that attaches from the manifold to fuel sensor.
2. vacuum line from turbo compressor housing port, to bottom port of hallman manual boost controller, then side port goes to the lower vacuum port on the turbosmart ultragate 38.
then the top vacuum port gets capped or left open? i know you are supposed to run it to a electronic boost gauge if you are running one but if your not..???
let me know
thanks
1. vacuum line from bov to vacuum line that attaches from the manifold to fuel sensor.
2. vacuum line from turbo compressor housing port, to bottom port of hallman manual boost controller, then side port goes to the lower vacuum port on the turbosmart ultragate 38.
then the top vacuum port gets capped or left open? i know you are supposed to run it to a electronic boost gauge if you are running one but if your not..???
let me know
thanks