XCal2 Help!!!

[ixtlan]

Need someone to read this file on there puter.
I show no changes to STFT and LTFT MAF Counts ect..
http://www.xmission.com/~ixtlan/20070504.csv

What do you see.
I just got my XC2 back from SCT after a month and it does the same as before.
Does the counts ect change for you?

 

[Hawgman]

Are you logging this on your XCal II and then downloading it to a PC or logging this via the XCal II to a laptop running livelink?

Something is definitely not right. I only see a couple of values change and it is a complete jump in those values, not a rise like I would expect. Plus you engine speed stays a constant 3156 from 3 seconds in to the run until right at the end. Does not vary a single tic. None of the fuel trim readings budge off of .747, MAF counts never change from 195. Only thing that changes at all is spark. For the first 3 seconds it is at 12, then jumps to 48.5 and remains constant for the remainder of the run.

 

[ixtlan]

Thanks for helping me out.
With the XC2 and then downloading to the puter.
Values change when viewing on the XC2.
Logging does not log them.

Can someone make me a configuration to log so I can upload it to the XC2 and eliminate my system as the problem?

The XC2 was just returned from SCT as repaired but nothing seems to have changed at all.
One month shot to hell for nothing.

My strategy is FBHR2G4

 

[ixtlan]

Here is something for you people to chew on.
When I log at the slow rate (Lower case signal options) guess what.
The XC2 works correctly!!!
So answer me this.
Why will it log slow, but not fast?
Ideas?
I want to make this work.

 

[Hawgman]

Honestly, I don't really remember anyone saying they have been successful with logging to the XCal in a stand alone configuration. Have you nosed around on the SCT forums to see if anyone might have a similiar issue or suggestions?

Go pick up a used craptop for a couple hundred somewhere and take care of your problem.

 

[ixtlan]

I suppose I am anal about these things.
I paid for the product that claimed a function that doesn't work.
I want to know why. Dammit it's my nature!!!

 

[Hawgman]

Like I said, ask over at SCT's forum. Maybe they will have some insight. I can pretty much promise you that just about everyone ( or possibly everyone but you ) that data logs here does it with the LL3 software and a laptop.

 

[ixtlan]

Like I said, ask over at SCT's forum. Maybe they will have some insight. I can pretty much promise you that just about everyone ( or possibly everyone but you ) that data logs here does it with the LL3 software and a laptop.

I guess I just need to break down and get a LT.
The Forum at SCT has been next to useless.
My experience with tech support itself is poor at best.
Post and a month later if your lucky you may get an answer from the tech support people.
E-Mail them and two weeks later they respond.
I ain't the only one with this problem either.
I heard good about them then like recently they went to hell in a hand basket.