Recent content by 300angryhorses

  1. 300angryhorses

    Rough Idle ( I searched )

    is it rough from start-up or does it occur after the car has warmed up? how rough is rough?
  2. 300angryhorses

    how to manually adjust sct x3

    here is a thread with some info and members who also have an interest: http://www.s197forum.com/forum/showthread.php?t=76481&highlight=tuning+sct there are more threads out there too. there are a lot of really knowledgeable, helpful people on this forum.
  3. 300angryhorses

    Motor mounts shot?

    I put billet poly mounts on mine, and they substantially increased the NVH, particularly at start-up and slow takeoffs.
  4. 300angryhorses

    Cam/Crank codes, please help!

    Links on thrust bearing failure causes: http://www.4secondsflat.com/Thrust_bearing_failures.html http://www.enginebuildermag.com/Article/1957/thrust_bearing_failure.aspx
  5. 300angryhorses

    Cam/Crank codes, please help!

    the block and the rest of the motor look fine so far. I'm still investigating.
  6. 300angryhorses

    Cam/Crank codes, please help!

    Mine was stock, so however Ford put it together.
  7. 300angryhorses

    Cam/Crank codes, please help!

    Got to the thrust washer. Clearly affecting the crankshaft endplay. #5 main bearing with the washer still in #5 main old vs. new
  8. 300angryhorses

    Cam/Crank codes, please help!

    yep .022. I'll check the thrust washer and bearings next.
  9. 300angryhorses

    Cam/Crank codes, please help!

    p0021/0022 code I put a dial indicator on the crankshaft. Ford specs are 0.0030-0.0148 inches.
  10. 300angryhorses

    Cam/Crank codes, please help!

    Thanks. I won't even get back to it until tomorrow evening at the earliest.
  11. 300angryhorses

    Cam/Crank codes, please help!

    Thanks. I just finished pulling the oil pan. I'll check the crank endplay and rest of the bottom end over the week.
  12. 300angryhorses

    Cam Tech Thread

    Fantastic info in this thread. Comp put out a nice videos on cam basics: wzKtaDke22k uKL8qIJuO40
  13. 300angryhorses

    Cam/Crank codes, please help!

    Yes, I can feel the grooves when I run a finger nail across them. I put in the Melling 340 pump, which is listed as a higher pressure pump, seemingly due to the higher pressure relief spring as far as i can tell. People have had VCT issues with the Melling billet pump, M176, which is supposed...
  14. 300angryhorses

    Cam/Crank codes, please help!

    pics of cams and journals. these show the worst of it.
  15. 300angryhorses

    Cam/Crank codes, please help!

    Here is a video of the pressure issue. I had to step away from it for a little while, but I'm back on it now. KCjiaNn8uHE
See more

Latest posts

Support us!

Support Us - Become A Supporting Member Today!

Click Here For Details

Sponsor Links

Banner image
Back
Top