In pic 3 me thinks that glove is flipping the finger .... haha
The moser axle housing does not have bump stops... Though by eyeball I can tell you that the UCA hits well after the stock bump stops would hit. I took the springs out and ran it up until "something" hit. That something was the Currie's UCA on the body...RedFury said:One thing I've been thinking - Mike, did you remove the bump stops from your axle?
There is such a long and unpleasant story here I wouldn't know where to begin... That and looking back, I have been a dumbass niceguy for too long, I know better than that...When youre ready to do a Currie housing...let me know.
Is that a 1350 or 1330 yoke in that picture?I'll be ordering the Currie UCA this week. Just for fun I took a photo of my CHE UCA mounted on the Currie rear end sitting in the garage. I suspect I would have the same interference issues if I used it instead of the Currie piece.
Thanks, Currie's 1350 yoke is a little shorter than Moser's and isn't machined nearly as much.1350
Have some pictures?^depends on which one youre talking about. we have a few different 1350 yokes.
Sure it is... spill it!!@#$ - sorry, this isn't the right place for this conversation...
Sure it is... spill it!
Have some pictures?
I have both a Currie and Moser center section both with 1350 yokes and the Currie is at least 1/2 inch shorter... Maybe I asked for the wrong one?